18KA INSTALLATION AND USER MANUAL

Slide Rail Connecting the Bow Riser and Magazine

Bow Riser-to-Magazine Slide Rail

These two screws can be moved to adjust the distance between the magazine and the bow riser, so that the bowstring stays centered in the magazine’s string groove and avoids wear on the bowstring.

These two on this side work on the same principle as well.

The bracket is mounted on the outside of the bow riser.

Align the screw holes.

Just tighten the screws.

The groove here in the magazine is the string groove, where the bowstring travels inside.

It is the groove where KANE hooks his thumb.

Note: This is not for locking the bracket wheel in place.

Remove the long screw at the rear of the magazine.

Pull the rear release module straight backward.

Fit the outer side of the magazine into the grooves of the upper and lower wheels on the bracket.

The rear wheel works the same way as well.

Place the bowstring into the magazine’s string groove.

Insert the release module back into the magazine.

Insert the fixing screw back in to complete the installation.

The front rail on the magazine can be used to mount a laser sight.

The middle rail can be used to mount a red dot sight or an optical scope.

Example of a laser mounted on the front end.

Installation complete diagram.

Steel Ball Loading Port。Uses 15 mm steel balls.

When loading steel balls, first pull the steel ball pusher back to this position until it locks in place.

The release trigger of the release mechanism. Pull the trigger to fire.

When loading steel balls, first pull the steel ball pusher back to this position until it locks in place.

Load the steel balls.

Release the steel ball pusher.

The steel ball pusher will hold the steel balls in place and feed them automatically.

When using it, hold the rear grip of the magazine and push the magazine straight toward the front of the bow. When you hear a click, it means a steel ball has been chambered and the bowstring has engaged the release module.

Push forward with your front hand and pull back with your rear hand to draw the bow.

Aim using the laser, a five-pin sight with a peep sight, or other aiming devices.

To fire, simply pull the release trigger.

The 18KA is a repeating compound bow with automatic magazine feeding. This compound bow is equipped with dry-fire protection. When the magazine is empty, the bowstring will not be able to latch. Do not force it, as this may cause damage. To extend the service life of the bowstring, you can wrap medical tape around the section of the bowstring that contacts the magazine. This helps prevent the magazine from wearing the bowstring due to improper installation or misalignment.