DX2 STEEL BALL MAGAZINE AND NIGHT VISION INSTALLATION & USER MANUAL

ALL MODULES FOR THE DX2 NIGHT VISION, MAGAZINE, AND AIMING ANCHOR GUIDE ROD

The screw holes on this bracket can be used to adjust the position of the night vision sight.

Magazine Mounting Module

Aiming Anchor Rod Bow Mounting Module

Aiming Anchor Rod Release Aid

Fix the night vision sight bracket through the screw holes on the inside of the bow window.

Position the magazine properly from the inside of the bow window.

Place the spacer on the outside of the bow window.

Place the mounting plate in position.

Secure it with screws.

The magazine should be level with the magnetic seat and maintain a certain distance from it.

This part must remain unobstructed so it can be pressed to release the ball.

Aiming Anchor Rod Module Installation

Remove the screw from the slider on the aiming anchor rod.

Secure the slider and the mounting module with screws.

DX2 INSTALLATION COMPLETED

DX2 USER MANUAL

Push the magazine pusher up to the top until it locks in place.

Load the steel balls.

Release the pusher rod.

Pull the pusher rod to push the steel balls down to the bottom.

Press the feeder to make the steel ball attach to the magnetic seat.

Make sure the steel ball is in place.

Press the release aid to open the jaws.

Let the jaws of the release aid clamp onto the D-loop.

When drawing the bow, do not place your index finger on the release trigger to avoid accidental firing.

Push the bow forward with your front hand and pull back with your rear hand to draw the bow.

After aiming, place your index finger on the release trigger and press downward to fire.

Press with your index finger to fire.